View source for FreeBSD's ppp(8) and u3g UMTS modem

==Drivers==
Many USB UMTS data sticks provide a serial port over which you can speak asynchronous PPP to the stick to establish a data connection. The hardware drivers contain more info on all functions provided, see [http://www.FreeBSD.org/cgi/man.cgi?query=u3g&apropos=0&sektion=4&manpath=FreeBSD+8.0-RELEASE&format=html u3g(4)] et al.

Usually, these devices present a umass(4) interface that provides a virtual CD-ROM with driver software, and one or more serial ports. On many sticks, the first serial port is the one you can use for data connections, but this isn't always the case, so you might need to google your particular model, or try them out one by one.

==ppp.conf==
I've switched off the PIN code query on the SIM (using a regular mobile phone), or see below. 

The APN data has been hard-coded in the chat script (see the line starting with 'AT+CGDCONT'; depending on your provider, you might need to change it. Google ''umts apn settings'' or similar to find the APN, and username and password, if required, for your network operator.

Sample [http://www.FreeBSD.org/cgi/man.cgi?query=ppp&apropos=0&sektion=8&manpath=FreeBSD+8.0-RELEASE&format=html ppp.conf]:
 u3g:
 	set device /dev/cuaU0.0
 	set speed 115200
 	# if the stick/the network fail to provide an IP unless you suggest one, the
 	# following line might help
 	#set ifaddr 10.0.0.1/0 10.0.0.2/0 255.255.255.0
 	# name of the APN
 	set phone "internet"
 	# username and password are often unnecessary, but almost always generic
 	set authname internet
 	set authkey  internet
 	set log local phase ipcp
 	set dial "ABORT BUSY TIMEOUT 2 \
 		\"\" \
 		AT OK-AT-OK \
 		AT+CFUN=1 OK-AT-OK \
 		AT+CMEE=2 OK-AT-OK \
 		AT+CSQ OK \
 		AT+CGDCONT=1,\\\"IP\\\",\\\"\T\\\" OK \
 		AT+CGACT? OK-AT-OK \
 		AT+CGATT? OK \
 		AT+CGCLASS? OK \
 		AT+COPS? OK \
 		ATD*99***1# CONNECT"
  	set crtscts on
 	# enable or disable updating /etc/resolv.conf with nameservers from the peer
 	disable dns
 	# add default route through this connection
 	add default HISADDR

==PIN Code Query==
AT command to switch off the PIN code query:
 AT+CLCK="SC",0,"XXXX"
and back on again:
 AT+CLCK="SC",1,"XXXX"